Introduction Thanks for choosing WiFi Bridge product. With this portable device, IP Camera and other IT products with Ethernet RJ45 port can access wireless network easily. Two kinds of application topology of are shown as below.
Wifi bridge between two floors. Then in the other room, I have a TrendNet AC1200 wireless bridge, which I use to connect my secondary wired LAN. Turn a simple consumer router into a highly configurable monster router. There are tutorials on the linked site to get you there.
Setup Please set this WiFi Bridge before using it, you can connect it to PC and run the autorun.exe in the CD. The Physical Connection for Setup as below. Running the SetupWizard 1) Please put into the CD-ROM, the systerm will automatically eject the disk and guide page, please refer to the right picture and click the corresponding label. 2) Please click Install Software label to run the set up program, if it’s shown the right picuture, please click Next, Click Cancel to exit the installationWizard. 3) If it’s shown the right picture, please click Yes to install WINPCAP program. 4) Please click Next, don’t need to do other settings until Finish.
5) After the installation is complete, please double click the desktop icon, the right picture shows it is searching the product MAC. 6) The right picture shows it is complete to search MAC, please Click Next.
7) The right picture shows the product has searched theWiFi network,please choose the correct WiFi Network. WPA automatically uses TKIP with dynamic encryption keys. Enter a passphrase on this screen. Encryption - TKIP is automatically selected as the encryption method. Click Next to proceed, or click. 8) The New settings will be shown. Click Next to save your new settings.
9) WiFi Bridge will attempt to connect the wireless network with the new settings. Make sure the Bridge’s Wireless LED is solidly lit or flashing.
This indicates that the Bridge has connected to the wireless network. Exit to exit the installationWizard.
To make sure WiFi Bridge is working, cut off all other internet connection to the PC (only reserve the connection between the PC and WiFi Bridge). If you setup WiFi Bridge successfully, the PC can.
In a recent project I put OpenWrt on a tiny Zsun wifi card reader. I also needed to install other packages so wanted internet access, but how? The device only has a single wifi connection (although putting an external ethernet jack is possible). The I discovered this method of being able to have the device in two modes simultaneously i.e. Connect to an access point for internet and also still being an access point in it's own right. My original project: Piratebox: More on the WinSCP program: Click Here to Subscribe Good source of electronic parts: Follow on Facebook DISCLAIMER: Unless otherwise stated all products shown in this video have been purchased personally. The description and video may contain links to products which might be affiliate links, so if you click on one of the product links I could receive a small commission.
This does not affect the price you pay. If you do purchase through my affiliate link this will help fund future videos, thank you for your support!